Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving all of Massachusetts

Martin Door Garage Door Cable Repair in Massachusetts

Frayed, snapped or slipped lift cables replaced and the door re-leveled. Typical cost $150-$350.

Need Martin Door garage door cable repair in Massachusetts? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Frayed, snapped or slipped lift cables replaced and the door re-leveled. Whether your Martin Door garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Signs you need Martin Door garage door cable repair

  • A cable hanging loose or off its drum
  • The door is crooked, with one side higher than the other
  • Frayed or rusty strands near the bottom bracket
  • The door stopped suddenly and won't move

What usually causes it

  • Rust and wear at the bottom bracket, where cables sit near wet ground
  • A broken spring that let the cable go slack and unwind
  • Drums that have slipped on the shaft
  • The door hitting an obstruction while closing

Safe checks before you call

  • Don't operate the door if a cable is loose. It can come off its tracks.
  • Look at both bottom corners for frayed or rusted cable.
  • Never loosen the bottom brackets, because they are under full spring tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our Martin Door garage door cable repair process

  1. Secure the door and remove spring tension
  2. Replace both lift cables so they wear evenly
  3. Re-seat the cables on the drums and set them to equal tension
  4. Inspect the bottom brackets, drums and springs
  5. Level and balance the door and test it

Typical Martin Door garage door cable repair prices

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Martin Door services

Martin Door Garage Door Cable Repair in Massachusetts

With large seasonal temperature swings in Massachusetts, track brackets and hinge screws work loose over time, and a loose track is the most common reason a door rubs, binds or comes off its rollers.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

We cover 389 cities and towns across Massachusetts. Find Martin Door garage door cable repair in your city:

Martin Door Garage Door Cable Repair: frequently asked questions

How much does Martin Door garage door cable repair cost in Massachusetts?

Martin Door Garage Door Cable Repair typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Martin Door garage door cable repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Martin Door garage door cable repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Martin Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Massachusetts or your city requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Massachusetts

Skylink Opener Circuit Board Replacement

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $175-$400

Allstar Remote & Keypad Programming

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $50-$150

Ryobi Remote & Keypad Programming

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $50-$150

Garaga Torsion Spring Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $200-$450

Martin Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Stanley Remote & Keypad Programming

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $50-$150

Overhead Door Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Raynor Garage Door Opener Installation

New chain, belt, screw-drive and wall-mount openers installed and programmed.

Typical $350-$800

Chamberlain Garage Door Opener Repair

Chamberlain is the retail line of The Chamberlain Group, sold at home centers. It uses the same Security+ 2.0 remote technology and myQ app as LiftMaster, so many accessories work with both brands.

Typical $125-$350

Craftsman Garage Door Opener Repair

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $125-$350

Raynor Commercial Door Operator Repair

Trolley, jackshaft and hoist operators repaired and adjusted.

Typical $300-$1,200

Marantec Garage Door Opener Repair

Marantec is a German manufacturer of residential and commercial door openers.

Typical $125-$350

Garage door stuck, noisy or broken?

Talk to a garage door technician in Massachusetts now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote